FS-8700-130 Notifier NCA2/NFS-3030 Manual Page 20 of 21
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: (408) 262-2299 Fax: (408) 262-2269 Toll Free: (888) 509-1970 email: support@fieldserver.com
LOOP CONTINUITY TEST FAIL LOOP 3
WALK TEST - FIRE PROTECTION IS LIMITED
LOOP CONTINUITY TEST FAIL LOOP 4
REMOTE PROG MODE ACCESSED
LOOP CONTINUITY TEST FAIL LOOP 5
DIA PROG. CHANGE DET. SERVICE REQUIRED
LOOP CONTINUITY TEST FAIL LOOP 6
ISIB DATA MESSAGE RECEIVED ERROR
LOOP CONTINUITY TEST FAIL LOOP 7
ISIB EXECUTIVE ROUTINE RE-ENTERED
LOOP CONTINUITY TEST FAIL LOOP 8
DIB TO SIB CABLE BAD OR MISSING
LOOP CONTINUITY TEST FAIL LOOP 9
UPLOAD/DOWNLOAD MESSAGE RECEIVED
LOOP CONTINUITY TEST FAIL LOOP 10
SIB PROG. CHANGE DET. SERVICE REQUIRED
HS-NCM SNIFFER MODE ACTIVE
SCB ASSEM. COM. VERIFIED FAILED
EXCEEDED CONNECTION LIMIT
8255 PORT CHIP CONTROL WORD CHECK FAILE
NETWORK COMMUNICATION LINK FAIL PORT A
NETWORK COMMUNICATION LINK FAIL PORT B
A.C. POWER LOSS. BACK UP ACTIVATED
Appendix C.3. Error Messages
Most error messages are associated with errors in parsing an incoming message from the Notifier panel. The most
likely cause is a mismatch in expected message format. The driver will flag one of the following error messages
and continue. In most cases the message currently being processed by the driver will also be printed so that any
problems can be easily diagnosed.
Two screens ‘System Errors’ and ‘Driver Messages’ exist for displaying errors.
The System Error Screen displays the error number and the Driver messages screen displays the error number,
description and the message received from the NCA/NCA2 Panel.
In debug mode the System Error screen will also include Driver messages.
The following Error Messages appear upon the ‘System Errors’ Screen
%d means numeric number
%s means string
Messages number 1, 3, 4 and 5 will be displayed just once if generated after rebooting or power cycling the
FieldServer.
#1 FYI. Incoming data is
being abandoned on
Port<%d> Node<%u>
Loop<%d>
Data_Type<%s>
Address<%d>
The FieldServer got a recognized
message on this particular port, Node,
loop, Address_Type and Address but
did not find a defined Map Descriptor.
To capture this data, add a new Map
Descriptor with the required parameters.
(13 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern